Hyundai Equus: Adaptive Front Lighting System Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Adaptive Front Lighting System / Adaptive Front Lighting System Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Adaptive Front Lighting System / Adaptive Front Lighting System Repair procedures
| Removal |
AFLS Unit
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the glove box housing (A). (Refer to the Body group - "Crash pad")
|
| 3. |
Disconnect the glove box housing connector (A).
|
| 4. |
Remove the DIS head unit. (Refer to DIS system) |
| 5. |
Remove the USB interface unit. |
| 6. |
Remove the front/rear parking assist system unit. (Refer to Front/Rear Parking assist system) |
| 7. |
Remove the AFLS unit(A) after removing connector and nuts(2EA).
|
| Installation |
AFLS Unit
| 1. |
Install the AFLS unit after connecting the connector. |
| 2. |
Install the front/rear parking assist system unit. |
| 3. |
Install the USB interface unit. |
| 4. |
Install the DIS head unit. |
| 5. |
Install the glove box housing. |
| 6. |
Connect the negative (-) battery terminal. |
Adaptive Front Lighting System Description and Operation
Description
AFLS Unit(ECU)
AFLS located in Cockpit Module is provided information of vehicle (steering wheel signal,vehicle speed, inclination of vehicle).
Based on provided information , it calc ...
Height Sensor Repair procedures
Removal
Height Sensor
1.
Disconnect the negative (-) battery terminal.
2.
Remove the height sensor linkage (A) installed on the front axle and rear axle.
(Number of height sensor : Air suspe ...
See also:
Power Latch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the trunk trim in the trunk.
(Refer to Body - "Trunk")
3.
Remove the power latch (A) after removing the bolts (2EA) and ...
Hood Lift Repair procedures
Replacement
•
When removing and installing the hood lifter, an assistant is necessary.
•
When removing the clips, use a clip remover.
1.
Using a screwdrive ...
Heated Oxygen Sensor (HO2S) Specifications
Specification
A/F Ratio (x)Output Voltage(V)RICH0.6 ~ 1.0LEAN0 ~ 0.4
ItemSpecificationHeater Resistance (x)Approx. 9.0 [21°C(69.8°F)]
...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com