Hyundai Equus: Blind Spot Detection Indicator Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Blind Spot Detecation system / Blind Spot Detection Indicator Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Blind Spot Detecation system / Blind Spot Detection Indicator Repair procedures
| Removal |
Blind Spot Detection Warnig Indicator
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the mirro (A).
|
| Installation |
Blind Spot Detection Warnig Indicator
| 1. |
Install the outside mirror. |
| 2. |
Connect the negative (-) battery terminal. |
| Inspection |
| 1. |
Verify that the mirror operates properly as shown in the below table.
BSD warning lamp
|
Troubleshooting
Troubleshooting
Examples of False-Alarm Occurrence from system characteristics (It’s not a problem)
-
Characteristics of EM Wave : EM Waves are reflected against
all material and especially ...
See also:
Steering Wheel Remote Controller (SWRC) Repair procedures
Inspection
1.
Check for resistance between terminals in each switch position.
[LH Top (Audio)]
SwitchConnectorterminalResistance(±5%)Volume Down6-7240 xSeek Down510 xMode940 xVolume Up1.69 kxSe ...
Closing the hood
1. Before closing the hood, check the following:
All filler caps in engine compartment must be correctly installed.
Gloves, rags or any other combustible material must be removed from the
eng ...
Electronic stability control (ESC)
The Electronic Stability control (ESC) system is designed to stabilize the vehicle
during cornering maneuvers. ESC checks where you are steering and where the vehicle
is actually going. ESC ap ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com