>
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim.
(Refer to Body - "Front door trim") |
3. |
Disconnect the rear door side curtain connector (A). |
4. |
Remove the rear door side curtain assembly (A) after loosening the screws. |
5. |
Remove the rear door side curtain motor (A) after loosening the screws. |
Installation |
1. |
Install the rear door side curtain assembly. |
2. |
Connect the connector and install the front door trim. |
Wheel nut tightening torque:
Steel wheel & aluminum alloy wheel: 65~79 lb·ft (9~11 kg·m)
If you have a tire gauge, remove the valve cap and check the air pressure. If
the pressure is lower than recommended, drive slowly to ...
Front Wiper Motor Repair procedures
Removal
1.
Remove the windshield wiper arm (A) and blade after removing a nut.
Tightening torque :
27 ~ 31 N.m (2.8 ~ 3.2 kgf.m, 20 ~ 23 lb-ft)
2.
If necessary of removing the wiper blad ...
Seat Belt Pretensioner (BPT) Repair procedures
Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the safety belt (A) by turning it in the direction of arrow using a flat ...