Hyundai Equus: Transmission Oil Temperature Sensor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Transmission Oil Temperature Sensor Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Transmission Oil Temperature Sensor Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the E Module connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification.
|
Transmission Oil Temperature Sensor Schematic Diagrams
Circuit Diagram
...
Output Speed Sensor Description and Operation
Description
The output speed sensor is a vital unit that measures the
rate of rotation of the transmission's turbine shaft and output shaft,
and delivers the readings to the TCM. The sensor pr ...
See also:
Fuel Line Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-)battery cable.
2.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in ...
Height Sensor Repair procedures
Removal
[Front Height Sensor]
•
Avoid suffering excessive impact.
•
Do not entering the water into pin inside.
•
Take care not to be damaged height senso ...
Brake Booster Repair procedures
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests.
1.
Run the engine for one or two minutes, and then stop it. If
the pedal depress ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com