Hyundai Equus: Output Speed Sensor Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Output Speed Sensor Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Output Speed Sensor Description and Operation
| Description |
The output speed sensor is a vital unit that measures the
rate of rotation of the transmission's turbine shaft and output shaft,
and delivers the readings to the TCM. The sensor provides critical input
data that's used in feedback control, damper clutch control, gear
setting control, line pressure control, clutch activation pressure
control, and sensor fault analysis.
Transmission Oil Temperature Sensor Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Output Speed Sensor Specifications
Specifications
x Type: Hall effect sensor
x Specifications
Operation condition (°C)°F((-)40~150)) -40~302Air gap(mm)in.1.3(0.0512)Output voltageHigh1.4Low0.7
...
See also:
Exhaust Manifold Repair procedures
Removal and Installation
1.
Disconnect the negative terminal (A) from the battery.
Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2.
Remove the engine room cover (A ...
Warning type
The system will activate when:
1.The system is on
2.Vehicle speed is above 9.3 mph (15 km/h)
3.Other vehicles are detected in the rear side
If a vehicle is detected within the boundary of the ...
Description and Operation
Description
Mobile Telemetics System (MTS)
Hyundai motor companies are now faced with the task of
shifting their paradigm from vehicle-centered services to customer
valuecentered services, wit ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com