>
Hyundai Equus Manuals

Hyundai Equus: Camshaft Position Sensor (CMPS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Camshaft Position Sensor (CMPS) Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) Repair procedures

Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
   
•
DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor.
[Bank 1/Intake]

[Bank 1/Exhaust]

[Bank 2/Intake]

[Bank 2/Exhaust]

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Apply the engine oil to the O-ring.
   
•
Insert the sensor in the installation hole and be careful not to damage.
   
•
Be careful not to damage the sensor housing and the connector.
•
Be careful not to damage the O-ring.
1.
Install in the reverse order of removal.
Camshaft position sensor installation bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
    Camshaft Position Sensor (CMPS) Schematic Diagrams
    Circuit Diagram ...

    Knock Sensor (KS) Description and Operation
    Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knockin ...

    See also:

    Reservoir Tank Repair procedures
    Removal     • Before replacing the relevant parts, use GDS equipment to fully discharge the air from the relevant parts. (Refer to Air Suspension System - "Repair procedures ...

    Specifications
    Specifications ItemSpecificationSteering GearTypeRack & PinionRack strokeManual144mmAIR136mmPower Steering MotorTypeBLDC (WET type)Voltage13.5VSteering angle (Max.)InnerR17Manual42.67°±1°3 ...

    Relay Box (Passenger Compartment) Repair procedures
    Inspection 1. The SJB can be diagnosed by using the GDS. The SJB communicates with the GDS which then displays inputs and outputs along with codes. 2. To diagnose the SJB function, select ...

    Categories

    Hyundai Equus Manuals

    2011-2026 Copyright www.heqmanual.com