>
Hyundai Equus Manuals

Hyundai Equus: Shift Lever Repair procedures - Automatic Transmission Control System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Shift Lever Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Shift Lever Repair procedures

Removal
1.
Remove the center console.
(Refer to Body - " Floor Consol")
2.
Disconnect the sports mode connector (A).

3.
Remove the shift cable assembly (A) from the shift lever assembly.

4.
Remove the shift lever assembly (A) by removing the bolts.
Tightening torque :
7.8 ~ 12.7 N.m (0.8 ~ 1.3 kgf.m, 5.8 ~ 9.4 lb-ft)

5.
Remove the clip (C ).
6.
Remove the shift cable (A) from the inhibitor by removing the nut (B).
Tightening torque :
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

7.
Remove the shift cable assembly (B) by removing the nuts (A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Installation
1.
Install in the reverse order of removal.
Adjustment
How To Adjust Shift Cable
1.
Insert the shift cable to the bracket and hold it with a new clip.
2.
Align the manual lever hole to the hole on the transmission case and hold the position with a bar.
3.
Eliminate shift cable free play of the shift cable.
4.
Firmly hold the special bolt with a spaner and tighten the nut (A) with the specified torque.
Tightening torque :
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

5.
Take off the bar holding the manual lever.
6.
Shifting the each position, check that the shift lever moves smoothly.
    Shift Lever Components and Components Location
    Components 1. Shift lever knob2. Shift lever boots3. Shift lever assembly4. Shift cable ...

    Driveshaft and axle
    ...

    See also:

    Sedan Under Body
    Under body Projected dimensions Tooling hole (O25)Front sub frame mounting pipe (O25)Tooling hole (O14)Front sub frame mounting pipe (O27)Tooling hole (O15)Tooling & paint drain hole (O6.6 ...

    Rear Wheel House Trim Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply pr ...

    Power Window Switch Repair procedures
    Inspection Driver Power Window Switch 1. When checking the driver power window switch, select a vehicle type and "IPM" menu. 2. Select "DDM (Driver Door Module)". 3. Select option "Input/ ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com