>

Hyundai Equus: Height Sensor Repair procedures - Adaptive Front Lighting System - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Height Sensor Repair procedures

Removal
Height Sensor
1.
Disconnect the negative (-) battery terminal.
2.
Remove the height sensor linkage (A) installed on the front axle and rear axle.
(Number of height sensor : Air suspension - 4EA, Non-air suspension - 2EA)
[Front]

[Rear]

3.
Remove the height sensor assembly after disconnecting the connector.
[Front]

[Rear]

4.
Remove the height sensor unit (A) after removing screws(2EA).
[Front]

[Rear]

Installation
Height Sensor
1.
Install the height sensor unit.
2.
Install the height sensor assembly after connecting the connector.
3.
Install the height sensor linkage on the front axle and rear axle.
4.
Connect the negative (-) battery terminal.
    Adaptive Front Lighting System Repair procedures
    Removal AFLS Unit 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to the Body group - "Crash pad") 3. Disconnect the glove box housing connect ...

    Multi-view Camera System
    ...

    See also:

    Fuel requirements
    Your new vehicle is designed to obtain maximum performance with UNLEADED FUEL, as well as minimize exhaust emissions and spark plug fouling. Your new vehicle is designed to use only unleaded fuel h ...

    Engine oil and filter
    The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the car is being driven in severe conditions, more frequent oil and filter changes are requir ...

    Temperature Control Actuator Description and Operation
    Description The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com