Hyundai Equus: Fuel Filler Door Release Actuator Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Fuel Filler Door / Fuel Filler Door Release Actuator Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Fuel Filler Door / Fuel Filler Door Release Actuator Repair procedures
| Inspection |
| 1. |
Remove the trunk room left side trim. |
| 2. |
Open the fuel filler door and remove the housing.
(Refer to the BD group - "Exterior")
|
| 3. |
Remove the connector and bolts (2EA).
|
| 4. |
Check for continuity between terminal No.1 and No.2. If there is no continuity replace the fuel filler door opener.
|
Components and Components Location
Component Location
1. Fuel filler door open switch2. Fuel filler door release actuator
...
Fuel Filler Door Open Switch Repair procedures
Inspection
1.
Remove the front door trim panel.
(Refer to BD group - "Front door")
2.
Check the switch (A) for continuity between the terminals.
3.
If the continuity is not as specified, ...
See also:
Middle Speed Sensor Description and Operation
Description
The middle speed sensor measures the rate of rotation of the
6C outer drum inside the transmission and delivers the readings to the
TCM. ...
Components and Components Location
Components Location
1. ECM (Engine Control Module) 2. Manifold Absolute Pressure Sensor (MAPS)3. Intake Air Temperature Sensor (IATS) 4. Engine Coolant Temperature Sensor (ECTS) 5. Throttle ...
Rear Hub - Carrier Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub .
Be care ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com