Hyundai Equus: Fuel Filler Door Open Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Fuel Filler Door / Fuel Filler Door Open Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Fuel Filler Door / Fuel Filler Door Open Switch Repair procedures
| Inspection |
| 1. |
Remove the front door trim panel.
(Refer to BD group - "Front door") |
| 2. |
Check the switch (A) for continuity between the terminals. |
| 3. |
If the continuity is not as specified, replace the switch.
|
Fuel Filler Door Release Actuator Repair procedures
Inspection
1.
Remove the trunk room left side trim.
2.
Open the fuel filler door and remove the housing.
(Refer to the BD group - "Exterior")
Do not reuse the fuel fill ...
Fuses And Relays
...
See also:
Auto Defogging Sensor Repair procedures
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remov ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, push the lever upward and release it with the lever
in the OFF position. The wipers will operate conti ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com