Hyundai Equus: Special Service Tools
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Mechanical System / General Information / Special Service Tools
| Special Service Tools |
| Tool (Number and name) | Illustration | Use |
| Crankshaft front oil seal installer (09231-2J310) (09231-H1100) |
| Installation of the front oil seal |
| Ring gear stopper (09231-2B100) (09231-3N100) |
| Removal and installation of the crankshaft pulley |
| Torque angle adapter (09221-4A000) |
| Installation of bolts & nuts needing an angular method |
| Valve stem seal installer (09222-28200) |
| Installation of the valve stem seal |
| Valve spring compressor & holder (09222-3K000) (09222-3C310) |
| Removal and installation of the intake or exhaust valves A : 09222-3K000 B : 09222-3C310 (holder) |
| Crankshaft rear oil seal installer (09231-2J400) (09231-H1100) |
| Installation of the crankshaft rear oil seal |
| Oil pan remover (09215-3C000) |
| Removal of oil pan |
| Oil seal installer (09231-2J510) (09231-H1100) |
| Installation of the cylinder head cover oil seal & timing chain upper cover oil seal. |
| Timing chain locking tool (09231-2J600) |
| Holds the timing chain with timing chain guide & timing chain tensioner arm during installation. |
Troubleshooting
Troubleshooting
SymptomSuspect areaRemedyEngine misfire with abnormal internal lower engine noises.Worn crankshaft bearings.Loose or damaged engine drive plate.Replace the crankshaft and bearings ...
See also:
Steering gear box, linkage & boots/lower arm ball joint
With the vehicle stopped and engine off, check for excessive free-play in the
steering wheel.
Check the linkage for bends or damage. Check the dust boots and ball joints for
deterioration, cracks ...
Cleaning the lap/shoulder belt webbing
Clean the belt webbing with any mild soap solution recommended for cleaning upholstery
or carpet. Follow the instructions provided with the soap. Do not bleach or re-dye
the webbing because this m ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Categories
Hyundai Equus Manuals
