>

Hyundai Equus: Description and Operation - Front Back view camera System - Body Electrical System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Description and Operation

Description
Front blind camera is a supplemental system that shows blind spot in front of the vehicle through the AV monitor.
The front blind camera will operate when you push the button and shift the transaxle into N(Neutral) or D(Drive) while driving less then 10km/h. After the vehicle stops for 4 minutes with the transaxle in N(Neutral) or D(Drive), it will bring up the previous screen.
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the AV monitor while backing-up.
   
This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there that can't see through the camera.
    Schematic Diagrams
    Circuit Diagram ...

    Repair procedures
    Removal Front Blind Camera 1. Remove the front bumper cover. (Refer to Body - "Front Bumper") 2. Remove the front blind camera (B) after removing the connector (A) and screws (4EA). Back ...

    See also:

    ETC (Electronic Throttle Control) System Schematic Diagrams
    Circuit Diagram ...

    Height Sensor Repair procedures
    Removal Height Sensor 1. Disconnect the negative (-) battery terminal. 2. Remove the height sensor linkage (A) installed on the front axle and rear axle. (Number of height sensor : Air suspe ...

    Cylinder Block Components and Components Location
    Components 1. Cylinder block bank cover2. Cylinder block bank cover gasket3. Cylinder block rear cover4. Cylinder block rear cover gasket5. Separator6. Drain plug7. O-ring8. Piston oil jet9. Chec ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com