>

Hyundai Equus: Front Seat Belt Buckle Repair procedures - Front Seat Belt - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Seat Belt Buckle Repair procedures

Replacement
1.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Disconnect the connectors (A).
3.
After loosening the mounting screws, then remove the memory power seat unit (B).

4.
Remove the front seat belt buckle connector wiring harness (A).

5.
After loosening the mounting bolt, then remove the front seat belt buckle (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5kgf.m, 28.9 ~ 39.8 lb-ft)

6.
Install in the reverse order of removal.
   
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.
    Front Seat Belt Buckle Components and Components Location
    Component Location 1. Front seat belt buckle ...

    Rear Seat Belt
    ...

    See also:

    Specifications
    Specifications ItemsSpecificationsRated voltageDC 12VOperating temperature range-22 ~ +176°F (-30°C ~ +80°C)Rated loadWasher switch0.2A (Relay load) ...

    Hood Seal Weatherstrip Repair procedures
    Replacement 1. Detach the clips, then remove the hood seal weatherstrip (A).     • Be careful not to scratch the hood seal weatherstrip. 2. Installation is the rev ...

    Description and Operation
    Description EHPS uses an electromotor to assist you in steering the vehicle. It senses the vehicle speed and road condition.If the engine is off or if the power steering system becomes inoperat ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com