>
Hyundai Equus: Rear Seat Back Cover Repair procedures
| Replacement |
| [LH] |
|
|
| 1. |
Remove the rear seat back assembly [LH].
(Refer to Rear Seat - "Rear Seat Assembly") |
| 2. |
Push the lock pin (B), remove the rear seat headrest (A).
|
| 3. |
Remove the rear seat back webbing guide cap (A). |
| 4. |
After loosening the mounting screws, then remove the rear seat back webbing guide (B).
|
| 5. |
After loosening the mounting bolt, then remove the rear seat air inhalation duct (A).
|
| 6. |
Pull out the rear seat headrest guides (A) while pinching both sides of the lower part of the guides, and remove them.
|
| 7. |
Disconnect the connector (A). |
| 8. |
After loosening the mounting bolts and screws, then remove the air duct assembly (B).
|
| 9. |
Remove the hog-ring clips (A) located in the rear part of the rear seat back.
|
| 10. |
After removing the hog-ring clips on the rear of seat back and remove the rear seat back cover (A).
|
| 11. |
Install in the reverse order of removal.
|
Rear Seat Back Cover Components and Components Location
Rear Seat Cushion Cover Components and Components LocationSteering Angle Sensor Description and Operation
Description
Steering Wheel Angle Sensor detects rotating direction of the
vehicle. Rotating direction detected by the sensor is communicated with
HECU as CAN signal involving information about ...
Removing and storing the spare tire
Turn the tire hold-down wing bolt counterclockwise.
Store the tire in the reverse order of removal.
To prevent the spare tire and tools from “rattling� while the vehicle is in motion,
stor ...
VSM OFF Switch Schematic Diagrams
Part Circuit Diagram
...