Hyundai Equus: Blind spot detection system (BSD) (If equipped)
Second generation VI (2009–2026) / Hyundai Equus 2009-2026 Owners Manual / Driving your vehicle / Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver while driving.
It senses the rear side territory of the vehicle and provides information to the driver.
(1) BSD (Blind spot detection) The warning range depends on your vehicle speed. However, if your vehicle is about 6 mph (10 km/h) faster than the other vehicle, the system will not warn you.
(2) LCA (Lane change assist) When a vehicle approaches you at high speed, the system will warn you.
(3) RCTA (Rear cross traffic alert) When your vehicle moves rearward, the sensor detects the approaching vehicle in the left and right side, the system will warn you.
WARNING
- Always check the road condition while driving for unexpected situations even though the BSD (Blind spot detection) system is operating.
- BSD (Blind spot detection) system is a system made for convenience. Do not solely rely on the system but always pay attention to drive safely.
- Operating conditions
- Warning type
- Detecting sensor
- Warning message
- Rear cross traffic alert
- Non-operating condition
- This device complies with Part 15 of the FCC rules.
Advanced vehicle safety management (AVSM) (If equipped)
AVSM detects the distance from the vehicle ahead with the sensor, to warn you
before collision and protect you in certain hazardous situations by using warning
message, warning sound and seat belt ...
Operating conditions
The indicator on the switch will illuminate when the BSD (Blind spot detection)
system switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds 9.3 mph (15 km/h), the system ...
See also:
Power steering pump, belt and hoses
Check the power steering pump and hoses for leakage and damage. Replace any damaged
or leaking parts immediately. Inspect the power steering belt (or drive belt) for
evidence of cuts, cracks, exce ...
Components and Components Location
Components Location
1. Compressor2. Air tank3. Air tube4. ECU5. Rear CDC Damper6. Rear spring7. Front air strut assembly8. G-Sensor9. Height sensor
...
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...
Categories
Hyundai Equus Manuals
