Hyundai Equus: Operating conditions
The indicator on the switch will illuminate when the BSD (Blind spot detection) system switch is pressed with the Engine Start/Stop Button ON.
If vehicle speed exceeds 9.3 mph (15 km/h), the system will activate. If you press the switch again, the switch indicator and system will be turned off.
If the ignition switch is turned OFF and ON the system returns to the previous state.
When the system is not used, turn the system off by turning off the switch.
When the system is turned on, the warning light will illuminate for 3 seconds on the outside rearview mirror.
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
(1) BSD (B ...
Warning type
The system will activate when:
1.The system is on
2.Vehicle speed is above 9.3 mph (15 km/h)
3.Other vehicles are detected in the rear side
If a vehicle is detected within the boundary of the ...
See also:
Fuel Pressure Sensor (FPS) Specifications
Specification
Pressure(kPa)Output Voltage(V)500.36002.511004.5
...
Heater Unit Components and Components Location
Component Location
Components
1. Heater Case (Left)2. Vent Door (Left)3. Temperature Door (Left)4. Floor Door (Left)5. Console Temperature Control Actuator (A) 6. Console Temperature Lever7. Con ...
Rear Bumper Cover Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply ...
Categories
Hyundai Equus Manuals
