>

Hyundai Equus: Detecting sensor - Blind spot detection system (BSD) (If equipped) - Driving your vehicle - Hyundai Equus 2009-2026 Owners ManualHyundai Equus: Detecting sensor

The sensors are located inside of the rear bumper.


The sensors are located inside of the rear bumper.

Always keep the rear bumper clean for the system to work properly.

    Warning type
    The system will activate when: 1.The system is on 2.Vehicle speed is above 9.3 mph (15 km/h) 3.Other vehicles are detected in the rear side If a vehicle is detected within the boundary of the ...

    Warning message
    If the detecting sensor performance is low or overheated by foreign substances on the rear bumper, the message will appear to notify the driver. Also, the message may appear when there is heavy ...

    See also:

    Center Pillar Trim Components and Components Location
    Component Location 1. Center pillar lower trim2.Center pillar upper trim ...

    Adaptive Front Lighting System Repair procedures
    Removal AFLS Unit 1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing (A). (Refer to the Body group - "Crash pad") 3. Disconnect the glove box housing connect ...

    Headlight
    When the headlight(light switch in the headlight or AUTO position) is on and all doors (and trunk) are locked and closed, the position light and headlight will come on for 15 seconds if any of the ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com