Hyundai Equus: VSM OFF Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Brake System / ESP(Electronic Stability Program) System / VSM OFF Switch Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Brake System / ESP(Electronic Stability Program) System / VSM OFF Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the airbag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring") |
| 3. |
Remove the TORX screws to remove the fixed bracket.
(Refer to Body Electrical System - "Steering Wheel Remote Controller ") |
VSM OFF Switch Schematic Diagrams
Part Circuit Diagram
...
Steering Angle Sensor Description and Operation
Description
Steering Wheel Angle Sensor detects rotating direction of the
vehicle. Rotating direction detected by the sensor is communicated with
HECU as CAN signal involving information about ...
See also:
Rear Disc Brake Repair procedures
Removal
1.
Remove the rear wheel & tire.
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Loosen the hose eye-bolt (B) and caliper mounting bolts (C), th ...
Checking the power steering fluid level
With the vehicle on level ground, check the fluid level in the power steering
reservoir periodically. The fluid should be between MAX and MIN marks on the side
of the gauge at the normal tempe ...
Repair procedures
Removal
1.
Remove the steering column upper and lower shrouds after loosening screws.
2.
Disconnect the multifunction switch connector (A).
3.
Remove the wiper & washer switch (A) by p ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com