>
Hyundai Equus: Brake Line Repair procedures
| Removal |
| 1. |
Remove the wheel & tire. |
| 2. |
Remove the brake hose clip (A).
Front
Rear
|
| 3. |
Disconnect the brake tube by loosening the tube flare nut.
|
| 4. |
Disconnect the brake hose from the brake caliper by loosening
the bolt. And loosen the braket bolt for disconnect the brake line.
Front
Rear
|
| Inspection |
| 1. |
Check the brake tubes for cracks, crimps and corrosion. |
| 2. |
Check the brake hoses for cracks, damage and fluid leakage. |
| 3. |
Check the brake tube flare nuts for damage and fluid leakage. |
| 4. |
Check the brake hose mounting bracket for crack or deformation. |
| Installation |
| 1. |
Installation is the reverse of removal.
|
| 2. |
After installation, bleed the brake system.
(Refer to Brake System - "Brake System Bleeding") |
| 3. |
Check the spilled brake oil. |
Brake Line Components and Components Location
Brake Pedal Components and Components LocationIf engine doesn't turn over or turns over slowly
1. Be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake
is set.
2. Check the battery connections to be sure they are clean and tight.
3. Turn on the interior light. If the ...
Accelerator Position Sensor (APS) Repair procedures
Inspection
1.
Connect a scantool on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification: Refe ...
Front Door Module Components and Components Location
Component Location
1. Front door module
...