>

Hyundai Equus: Trunk Lid Latch Repair procedures - Trunk Lid - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Trunk Lid Latch Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Disconnect the trunk lid latch connector (A) and remove the trunk lid latch cable (B).
3.
After loosening the mounting bolts, then remove the trunk lid latch assembly (C).

Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

4.
Install in the reverse order of removal.
   
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
•
Adjust the trunk lid alignment.
•
Make sure the connectors are connected in properly.
    Trunk Lid Latch Components and Components Location
    Component Location 1. Trunk lid latch ...

    Trunk Lid Key Holder Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    See also:

    Front Rear Parking Assist System Switch Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad lower panel and then push t ...

    Fuel Tank Pressure Sensor (FTPS) Specifications
    Specification Pressure [kPa (kgf/cmx, in H2O)Output Voltage (V)-6.67 (-0.068, -26.8)0.502.5+6.67 (0.068, 26.8)4.5 ...

    ON/OFF Solenoid Valve Schematic Diagrams
    Circuit Diagram ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com