>

Hyundai Equus: Trunk Lid Key Holder Repair procedures - Trunk Lid - Body (Interior and Exterior) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Trunk Lid Key Holder Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Loosen the trunk lid key holder mounting bolts.
3.
Disconnect the trunk lid key holder cable (A) and remove the trunk lid key holder (B).

Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

4.
Install in the reverse order of removal.
   
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
•
Replace any damaged clips.
    Trunk Lid Latch Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply pr ...

    Trunk Lid Back Panel Components and Components Location
    Component Location 1. Trunk lid back panel ...

    See also:

    Keep your car clean
    The best way to prevent corrosion is to keep your car clean and free of corrosive materials. Attention to the underside of the car is particularly important. If you live in a high-corrosion area ...

    Rear Curtain Switch Repair procedures
    Removal Floor Console Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly") 3. Remove the connector ...

    ECU Schematic Diagrams
    Circuit diagram 1. ECU Connector 2. ECU Terminal function TerminalFunction1Ground2Ground3IGN4Battery5Battery6-7-8-9-10-11-12Reverse Valve 1x(M1 Low Side)13Ambiance Valve14Reverse Valve 2x( ...

    Categories

    Hyundai Equus Manuals

    © 2011-2025 Copyright www.heqmanual.com