>

Hyundai Equus: Rear Pillar Trim Repair procedures - Interior Trim - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Rear Pillar Trim Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Remove the rear seat back assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
4.
Slighty remove the rear door body side weatherstrip.
5.
Remove the rear wheel house trim.
(Refer to Interior Trim - "Rear Wheel House Trim")
6.
Using a screwdriver or remover, remove the rear pillar trim (A).

7.
Install in the reverse order of removal.
   
•
Replace any damage clips.
    Rear Pillar Trim Components and Components Location
    Component Location 1. Rear pillar trim ...

    Rear Wheel House Trim Components and Components Location
    Component Location 1. Rear wheel house trim ...

    See also:

    Assist Handle Components and Components Location
    Component Location 1. Assist handle ...

    4&OD Clutch Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Specifications
    Specifications ItemsSpecificationRated voltageDC 12VOperating voltage9V ~ 16VOperating speed15x/h ~ 250x/hSensible distance70m (Sedan)Curvature radiusStart : More than 100mStop : Less than 70mFre ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com