>

Hyundai Equus: Sub Fuel Sender Repair procedures - Fuel Delivery System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Sub Fuel Sender Repair procedures

Removal
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
2.
Folding the rear seat cushion.
3.
Remove the fuel pump service cover (A) after loosening the screws.

4.
Disconnect the sub fuel sender connector (A).
5.
Remove the sub fuel sender (B) from the fuel tank after removing mounting bolts.

Installation
1.
Install in the reverse order of removal.

Sub fuel sender installation bolt :
2.0 ~ 2.9 N.m (0.2 ~ 0.3 kgf.m, 1.4 ~ 2.2 lbf.ft)

   
When installing the sub fuel sender, be careful not to get the seal-ring entangled.
    Fuel Pump Repair procedures
    Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Folding the rear seat cushion. 3. Remove the fuel pump ...

    Fuel Filter Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System -"Release Residual Pressu ...

    See also:

    Specifications
    Specifications ContentValueAFLSNominal VoltageDC 13.5VMax VoltageDC 18.5VRated VoltageDC 10~16VOperating Temperature-40°C ~ +85°COperating CurrentMAX. 200mA ...

    Power Trunk Module Drive Unit Components and Components Location
    Component Location 1. Gear motor2. Drive bracket3. Push rod4. Gear5. Drive arm6. Power trunk module control unit7. Push rod pin ...

    Troubleshooting
    Troubleshooting Ignition System SymptomSuspect AreaRemedyEngine will not start or is hard to start (Cranks OK)Ignition lock switchInspect ignition lock switch, or replace as requiredIgnition c ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com