Hyundai Equus: ON/OFF Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / ON/OFF Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / ON/OFF Solenoid Valve Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the E Module connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
ON/OFF Solenoid Valve Schematic Diagrams
Circuit Diagram
...
Inhibitor Switch Description and Operation
Description
Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...
See also:
High Mounted stop lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear package trim (A).
(Refer to Body - "Interior trim")
3.
Remove the high mounted stop lamp (A) after removing sc ...
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...
Cleaning the lap/shoulder belt webbing
Clean the belt webbing with any mild soap solution recommended for cleaning upholstery
or carpet. Follow the instructions provided with the soap. Do not bleach or re-dye
the webbing because this m ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com