>
Hyundai Equus: Seat Heater Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the floor console upper cover.
(Refer to Body - "Floor Console Assembly") |
| 3. |
Remove the seat heater switch assembly (A) after disconnecting the connector and loosening the screws.
|
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the armrest from the second seat.
(Refer to Body - "Rear Seat Assembly") |
| 3. |
Using the remover, remove the armrest upper cover (A).
|
| 4. |
Remove the switch (A) from the armrest upper cover.
|
Air Lumber Support Switch Repair procedures
Electronic Active Headrest Description and OperationHeated Oxygen Sensor (HO2S) Troubleshooting
Signal Waveform
Fig.1) The signal waveforms of front HO2S(the upper) and heater(the lower) at idle
Fig.2) The signal waveforms of rear HO2S(the upper) and heater(the lower) at idle
Fig.3) Typical ...
Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band
across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left
on the tire. Replace the tire when ...
Filter replacement
It must be replaced when necessary, and should not be washed.
You can clean the filter when inspecting the air cleaner element. Clean the filter
by using compressed air.
Main air cleaner
1. ...