Hyundai Equus: Emission control system
Second generation VI (2009–2026) / Hyundai Equus 2009-2026 Owners Manual / Maintenance / Emission control system
The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Owner’s Handbook & Warranty Information booklet in your vehicle.
Your vehicle is equipped with an emission control system to meet all applicable emission regulations. There are three emission control systems, as follows.
(1) Crankcase emission control system
(2) Evaporative emission control system
(3) Exhaust emission control system
In order to assure the proper function of the emission control systems, it is recommended that you have your car inspected and maintained by an authorized EQUUS dealer in accordance with the maintenance schedule in this manual.
Caution for the Inspection and Maintenance Test (With Electronic Stability Control (ESC) system)
- To prevent the vehicle from misfiring during dynamometer testing, turn the Electronic Stability Control (ESC) system off by pressing the ESC switch.
- After dynamometer testing is completed, turn the ESC system back on by pressing the ESC switch again.
- 1. Crankcase emission control system
- 2. Evaporative emission control (including ORVR: Onboard Refueling Vapor Recovery) system
- 3. Exhaust emission control system
Cleaning the interior window glass
If the interior glass surfaces of the vehicle become fogged (that is, covered
with an oily, greasy or waxy film), they should be cleaned with glass cleaner. Follow
the directions on the glass clea ...
1. Crankcase emission control system
The positive crankcase ventilation system is employed to prevent air pollution
caused by blow-by gases being emitted from the crankcase.
This system supplies fresh filtered air to the crankcase thr ...
See also:
Manifold Absolute Pressure Sensor (MAPS) Description and Operation
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute
pressure of the surge tank and transfers the analog si ...
Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) ...
Center Pillar Trim Repair procedures
Replacement
[Center Pillar Lower Trim]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
...
Categories
Hyundai Equus Manuals
