>
Hyundai Equus Manuals

Hyundai Equus: Front Seat Assembly Repair procedures - Front Seat - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Seat Assembly Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly Repair procedures

Replacement
1.
Remove the safety belt (A) by turning it in the direction of arrow using a flat-head screwdriver.

2.
Remove the front seat track mounting cover.
3.
After loosening the mounting bolts and nuts, remove the front seat assembly (A).
Tightening torque :
Bolts : 34.3 ~ 53.9 N.m (3.5 ~ 5.5 kgf.m, 25.3 ~ 39.8 lb-ft)
Nuts : 23.5 ~ 35.3 N.m (2.4 ~ 3.6 kgf.m, 17.4 ~ 26.0 lb-ft)

4.
Disconnect the front seat integration connector (A).
[Driver's]

[Passenger's]

5.
Disconnect the rear monitor image cable connector (A).

6.
Install in the reverse order of removal.
   
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
•
Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
•
Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
•
Set the seat into the most rearward position. Check the front mounting bolt completely.
•
Check that the seat operates to and fro smoothy and the locking portion locks properly.
    Front Seat Assembly Components and Components Location
    Component Location 1. Front seat assembly ...

    Front Seat Shield Outer Cover Components and Components Location
    Component Location 1. Front seat front shield outer cover2. Front seat rear shield outer cover ...

    See also:

    Panic Button
    Press the Panic button (4) for more than one second. The horn sounds and hazard warning lights flash for about 30 seconds. To cancel the panic mode, press any button on the Smart Key. ...

    Crash Pad Lower Panel Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    Purge Control Solenoid Valve (PCSV) Description and Operation
    Description Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister and the intake manifold. It is a solenoid valve and is open when the ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com