Hyundai Equus: Rear Curtain Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Rear Curtain System / Rear Curtain Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Rear Curtain System / Rear Curtain Repair procedures
| Inspection |
Connect the battery voltage and check the rear curtain motor
rotation. If the motor does not operate properly, substitute with a
known-good rear curtain motor and check for proper operation.
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the rear package tray trim (A) after removing the rear seat.
(Refer to Body - "Rear Package Tray Trim")
|
| 3. |
Remove the rear curtain (A) after disconnecting the connector and rear curtain mounting nuts.
|
| 4. |
Remove the rear curtain motor (A) after loosening the screws.
|
| Installation |
| 1. |
Install the rear curtain after connecting the connector. |
| 2. |
Install the rear package trim and rear seat. |
| 3. |
Connect the negative battery terminal. |
Description and Operation
Description
You can up & down rear curtain automatically by pressing
the rear curtain switch. Rear curtain protect passenger from a direct
ray of light by covering rear glass.
...
Rear Curtain Switch Repair procedures
Removal
Floor Console Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console upper cover.
(Refer to Body - "Floor Console Assembly")
3.
Remove the connector ...
See also:
Components and Components Location
Component Location
1. DDM (Driver Door Module)2. ADM (Assist Door Module)3. IPM (Instrument Panel Module)4. Door lock knob5. Trunk lid actuator6. Front door lock actuator7. Rear door lock actuato ...
Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the
evaporative emission control system and is installed on the fuel tank,
the fuel pump, or the canister. It checks the purge con ...
Brake Pedal Repair procedures
Removal
1.
Remove the lower crash pad.
(Refer to Body - "Crash Pad")
2.
Disconnect the stop lamp switch connector (A).
3.
Remove the mounting bracket nut (B).
Tightening torque :
14. ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com