>
Hyundai Equus Manuals

Hyundai Equus: Hood Latch Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Hood Latch Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Repair procedures

Replacement
1.
Remove the hood latch cover (A) mounting clip.
(Refer to Engine Mechanical System - "Active Air Flap(AAF)")
2.
Loosen the hood latch (B) mounting bolts.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

3.
Disconnect the connector (A), then remove the wiring mounting clips.

4.
Installation is the reverse of removal.
   
•
Make sure the hood latch release cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.
•
Adjust the latch alignment.
    Hood Latch Components and Components Location
    Component Location 1. Hood latch assembly ...

    Trunk Lid
    ...

    See also:

    Warning message
    If the detecting sensor performance is low or overheated by foreign substances on the rear bumper, the message will appear to notify the driver. Also, the message may appear when there is heavy ...

    Intake Manifold Components and Components Location
    Components 1. Purge control solenoid valve (PCSV) and hose2. PCV hose3. ETC module4. Intake manifold module5. MAP sensor ...

    Mode Control Actuator Description and Operation
    Description The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com