>
Hyundai Equus Manuals

Hyundai Equus: Manifold Absolute Pressure Sensor (MAPS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Specification: Refer to "Specification"
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the manifold absolute pressure sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor from the surge tank.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
   
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Install in the reverse order of removal.
Manifold absolute pressure sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
    Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams
    Circuit Diagram ...

    Intake Air Temperature Sensor (IATS) Description and Operation
    Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of t ...

    See also:

    Head Lamps Repair procedures
    Inspection Head Lamp Relay Inspection 1. Pull out the head lamp relay (Low) (A) from the engine compartment relay box. A : Head lamp(Low) relay 2. Check for continuity between terminals. The ...

    Fuel Pressure Sensor (FPS) Specifications
    Specification Pressure(kPa)Output Voltage(V)500.36002.511004.5 ...

    Memory Power Seat Switch Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the door trim (A) after loosening mounting screws. (Refer to Body - "Front Door Trim") 3. Remove the memory power seat c ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com