>

Hyundai Equus: Front Door Outside Handle Repair procedures - Front Door - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Door Outside Handle Repair procedures

Replacement
1.
Remove the hole plug (B).
2.
After loosening the mounting bolt, then remove the front door outside handle cover (A).

Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

3.
Remove the front door outside handle (A) by sliding it rearward.

4.
Disconnect the front door outside handle connector (A).

5.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Make sure the door locks/unlocks and opens/closes properly.
    Front Door Outside Handle Components and Components Location
    Component Location 1. Front door outside handle ...

    Rear Door
    ...

    See also:

    6 Speed Clutch Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Limitations of the system
    The smart cruise control system may have limits to its ability to detect distance to the vehicle ahead due to road and traffic conditions. On curves On curves, the smart cruise control syst ...

    Radiator Grill Repair procedures
    Replacement     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply p ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com