>
Replacement |
1. |
Pull it up and remove the rear seat cushion assembly (A). |
2. |
Install in the reverse order of removal.
|
1. |
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly") |
2. |
After loosening the mounting bolts and then pull it up and remove the rear seat back assembly (A).
|
3. |
Disconnect the rear seat back extension connector (A) and airbag connector (B). |
4. |
Install in the reverse order of removal.
|
Heater Control Unit Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim")
3.
To remove the crash pad under cover [RH] (A), press both ...
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wi ...
Smart Key Unit Repair procedures
Removal
Smart Key Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel after loosening the mounting screws.
(Refer to Body - "Crash Pad Lower Panel")
...