>
Hyundai Equus: Fuel Pressure Sensor (FPS) Repair procedures
| Inspection |
| 1. |
Connect the GDS on the Data Link Connector (DLC). |
| 2. |
Check the output voltage of fuel pressure sensor (FPS).
|
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-)battery cable. |
| 2. |
Folding the rear seat cushion. |
| 3. |
Remove the fuel pump service cover (A) after loosening the screws.
|
| 4. |
Disconnect the fuel pressure sensor connector (A). |
| 5. |
Remove the fuel pressure sensor fixing pin (B) in the direction of the arrow . |
| 6. |
Remove the fuel pressure sensor (C) from the fuel pump.
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Fuel Pressure Sensor (FPS) Troubleshooting
Fuel Line Repair proceduresIn-car Sensor Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Blow warm air into the in-car sensor air inlet. Measure the sensor resistance between 1 and 3 terminals.
1. Sensor Ground 2. Motor (-)3. Incar ...
Description and Operation
Description of ESP
Optimum driving safety now has a name: ESP, the Electronic Stability Program.
ESP recognizes critical driving conditions, such as panic
reactions in dangerous situations, a ...
Cup holder
WARNING - Hot liquids
Do not place uncovered cups of hot liquid in the cup holder while the
vehicle is in motion. If the hot liquid spills, you could be burned. Such a
burn to the driver cou ...