Hyundai Equus: Front Rear Parking Assist System Switch Repair procedures
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Body Electrical System / Front / Rear Parking Assist System / Front Rear Parking Assist System Switch Repair procedures
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Body Electrical System / Front / Rear Parking Assist System / Front Rear Parking Assist System Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Remove the crash pad lower panel and then push the rear parking assist switch (A) to remove it.
|
| Installation |
| 1. |
Install the rear parking assist switch after connecting the connector. |
| 2. |
Install the crash pad lower panel. |
| Inspection |
| 1. |
Check that continuity exists between the terminals. If there is no continuity, replace the seat heater switch.
|
See also:
Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform
This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at idle. ...
Repair procedures
Inspection
Tolerance Compensation
Tolerance compensation compensates for the error margins of
Multi-view video that occur due to the installation tolerance when the
four cameras that comprise ...
Intake Actuator Description and Operation
Description
The intake actuator is located at the blower unit. It
regulates the intake door by a signal from the control unit. Pressing
the intake selection switch will shift between recirculat ...
Categories
Hyundai Equus Manuals
© 2011-2025 Copyright www.heqmanual.com