Hyundai Equus: Hood Weatherstrip Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Hood / Hood Weatherstrip Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Hood / Hood Weatherstrip Repair procedures
| Replacement |
| 1. |
Remove the glue on end of both sides before removing the hood weatherstrip (A).
|
| 2. |
Installation is the reverse of removal. |
Hood Seal Weatherstrip Repair procedures
Replacement
1.
Detach the clips, then remove the hood seal weatherstrip (A).
•
Be careful not to scratch the hood seal weatherstrip.
2.
Installation is the rev ...
Hood Latch Release Handle Components and Components Location
Component Location
1. Hood latch release handle
...
See also:
Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Specification: Refer to "Specification"
...
Water pump Repair procedures
Removal and Installation
Water Pump
1.
Disconnect the negative terminal (A) from the battery.
Tightening torque :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2.
Remove the air du ...
Cleaning the lap/shoulder belt webbing
Clean the belt webbing with any mild soap solution recommended for cleaning upholstery
or carpet. Follow the instructions provided with the soap. Do not bleach or re-dye
the webbing because this m ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com