>

Hyundai Equus: Hood Latch Release Handle Components and Components Location - Hood - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Hood Latch Release Handle Components and Components Location

Component Location

1. Hood latch release handle


    Hood Weatherstrip Repair procedures
    Replacement 1. Remove the glue on end of both sides before removing the hood weatherstrip (A).     • Be careful not to scratch the hood weatherstrip. 2. Installat ...

    Hood Latch Release Handle Repair procedures
    Replacement 1. After loosening the mounting screw, then remove the hood latch release handle (A). 2. Installation is the reverse of removal.     • Make sure the hood la ...

    See also:

    Limousine Interior
    Interior A Front inner pillar tooling hole (O9)Cowl cross bar mounting hole (O11)Front door checker mounting hole (O11)Side sill inner reinforcement tooling hole (O7)Seat belt height adjuster upp ...

    Starter Repair procedures
    Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the starter cable (A) from the B terminal on the solenoid, and the connector (B) from the S ter ...

    Filter inspection
    The climate control air filter should be replaced every 15,000 miles (24,000 km). If the vehicle is operated in severely air-polluted cities or on dusty rough roads for a long period, it should be ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com