>
Replacement |
1. |
Remove the glue on end of both sides before removing the hood weatherstrip (A).
|
2. |
Installation is the reverse of removal. |
Trunk Lid Back Panel Components and Components Location
Component Location
1. Trunk lid back panel
...
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly.
Allow adequate stopping distance because brake perfo ...
Camshaft Position Sensor (CMPS) Troubleshooting
Signal Waveform
This example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at idle. ...