>
Inspection |
1. |
Connect the GDS on the Data Link Connector (DLC). |
2. |
Measure the output voltage of the MAPS at idle and IG ON.
|
Gate operator & Canadian programming
During programming, your handheld transmitter may automatically stop transmitting.
Continue to press the Integrated HomeLink® Wireless Control System button (note
steps 2 through 4 in the Standard ...
Trunk Lid Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply prote ...
Rheostat Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the lower crash panel and then disconnect the rheostat connector.
3.
Check for intensity of new rheostat switch. If th ...