Hyundai Equus: Gate operator & Canadian programming
Second generation VI (2009–2026) / Hyundai Equus 2009-2026 Owners Manual / Features of your vehicle / Mirrors / Gate operator & Canadian programming
During programming, your handheld transmitter may automatically stop transmitting. Continue to press the Integrated HomeLink® Wireless Control System button (note steps 2 through 3 in the Programming portion of this document) while you press and re-press ("cycle") your handheld transmitter every two seconds until the frequency signal has been learned. The indicator light will flash slowly and then rapidly after several seconds upon successful training.
Programming
To train most devices, follow these instructions:
1. For first-time programming, press and hold the two outside buttons (
,
), HomeLink® Channel 1 and Channel 3, until the indicator light begin ...
Operating HomeLink®
To operate, simply press and release the programmed HomeLink® button. Activation
will now occur for the trained device (i.e. garage door opener, gate operator, security
system, entry door lock, h ...
See also:
SRS Control Module (SRSCM) Repair procedures
Removal
1.
Turn the engine OFF.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Remove the floor console assembly.
(Refer to Body - ...
Sunroof Assembly Repair procedures
Replacement
•
Put on glove to protect your hands.
•
Take care not to scratch the interior trims and other parts.
1.
Remove the roo ...
Glove Box Housing Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply pr ...
Categories
Hyundai Equus Manuals
