>
Hyundai Equus Manuals

Hyundai Equus: Glove Box Housing Repair procedures - Crash Pad - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Glove Box Housing Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Glove Box Housing Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Disconnect the stopper (B) from the glove box (A).

2.
Disconnect the air damper (A) from the glove box (B).

3.
Disconnect the pins (A) and then remove the glove box (B).

4.
After loosening the mounting screws, then remove the glove box housing (A).

5.
Disconnect the glove box lamp connector (A).

6.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
    Glove Box Housing Components and Components Location
    Component Location 1. Glove box housing ...

    Steering Column Shroud Panel Components and Components Location
    Component Location 1. Steering column shroud lower panel2. Steering column shroud upper panel ...

    See also:

    Over Pressure Valve (OPV) Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System -"Release Residual Pressu ...

    Rear combination lamp Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Loose the nuts holding the rear combination lamp (outside) then disconnect the connector (A). 3. Remove the rear combination la ...

    Lane Departure Warning System (LDWS) Unit Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the LDWS unit cover (A). 3. Remove the LDWS unit connector (A). 4. Remove the front side of roof trim to remove the L ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com