>
Hyundai Equus: Rear Assist Arm Repair procedures
| Removal |
| 1. |
Remove the rear wheel and tire (A) from rear hub .
|
| 2. |
Remove the split pin and castle nut (A).
|
| 3. |
Disconnect the rear assist arm with the rear carrier using a SST (09568-2J100).
|
| 4. |
Disconnect the rear assist arm (B) from the rear sub frame by loosening the bolt & nut (A).
|
| 5. |
Install in the reverse order of removal. |
| 6. |
Check the alignment.
(Refer to Tires/Wheels - "Alignment")
|
| Inspection |
| 1. |
Check the bushing for wear and deterioration. |
| 2. |
Check the ball joint for rotating torque. |
| 3. |
Check the assist arm for deformation. |
Rear Upper Arm Repair procedures
Trailing Arm Repair proceduresIntake Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 ...
Crash Pad Under Cover Repair procedures
Replacement
[LH]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and ap ...
Troubleshooting
Failure Diagnosis
1.
In principle, ESP and TCS controls are prohibited in case of ABS failure.
2.
When ESP or TCS fails, only the failed system control is prohibited.
3.
However, when the ...