Hyundai Equus: 4&OD Clutch Control Solenoid Valve Description and Operation

6 Speed Clutch Control Solenoid Valve Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

4&OD Clutch Control Solenoid Valve Specifications

Specifications Direct control VFS[4&OD/C] x Control type : Normal high type Control Pressure kpa (kgf/cmx, psi)0~1569.06 (0~16,0~227.57)Current value(mA)0~1100 Internal resistanc ...

See also:

Repair procedures
On-vehicle Inpection     • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) ...

Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery. 2. Remove the crash pad lower panel (A). (Refer to Body - "Crash Pad Lower Panel") 3. Remove the crash pad lower panel and then push the bl ...

Sunroof Switch Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console then remove the 2 screws holding the overhead console. Disconnect the sw ...