Hyundai Equus: Trailing Arm Repair procedures
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Suspension System / Rear Suspension System / Trailing Arm Repair procedures
Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Suspension System / Rear Suspension System / Trailing Arm Repair procedures
| Removal |
| 1. |
Remove the rear wheel and tire (A) from rear hub .
|
| 2. |
Loosen the bolt & lock nut (A).
|
| 3. |
Disconnect the trailing arm (B) from the rear axle by loosening the bolt & nut (A).
|
| 4. |
Install in the reverse order of removal. |
| 5. |
Check the alignment.
(Refer to Tires/Wheels - "Alignment")
|
| Inspection |
| 1. |
Check the bushing for wear and deterioration. |
| 2. |
Check the trailing arm deformation. |
| 3. |
Check the all bolts. |
Rear Assist Arm Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage ...
Rear Lower Arm Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage ...
See also:
Hood Seal Weatherstrip Repair procedures
Replacement
1.
Detach the clips, then remove the hood seal weatherstrip (A).
•
Be careful not to scratch the hood seal weatherstrip.
2.
Installation is the rev ...
Auto Defogging Sensor Repair procedures
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remov ...
Checking the engine oil level
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...
Categories
Hyundai Equus Manuals
© 2011-2025 Copyright www.heqmanual.com