>
Hyundai Equus Manuals

Hyundai Equus: Rear Lower Arm Repair procedures - Rear Suspension System - Suspension System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Rear Lower Arm Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Suspension System / Rear Suspension System / Rear Lower Arm Repair procedures

Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
   
•
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

2.
Disconnect the rear stabilizer link (C) & height sensor (B) from the rear lower arm by loosening the nut (A).
Tightening torque
Height sensor : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
Stabilizer link : 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

3.
Loosen the bolt (A), nuts (B), flange bolt (C), lock nuts (D).
Tightening torque
Axle : 140.0 ~ 160.0 N.m (14.0 ~ 16.0 kgf.m, 101.0 ~ 116.0 lb-ft)
Damper : 140.0 ~ 160.0 N.m (14.0 ~ 16.0 kgf.m, 101.0 ~ 116.0 lb-ft)

4.
Install in the reverse order of removal.
5.
Check the alignment.
(Refer to Tires/Wheels - "Alignment")
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the rear lower arm deformation.
3.
Check the all bolts.
4.
Check the coil spring pad for deterioration and deformation.
    Trailing Arm Repair procedures
    Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     • Be careful not to damage ...

    Rear Stabilizer Bar Repair procedures
    Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     • Be careful not to damage ...

    See also:

    Snowy or icy conditions
    To drive your vehicle in deep snow, it may be necessary to use snow tires or to install tire chains on your tires. If snow tires are needed, it is necessary to select tires equivalent in size and ...

    Components and Components Location
    Component Location 1. Hood switch2. Burglar horn3. BCM4. Key warning switch5. Front door switch6. Front door lock actuator & switch7. Rear door lock actuator & switch8. Rear door switch9. ...

    Front Wiper Motor Repair procedures
    Removal 1. Remove the windshield wiper arm (A) and blade after removing a nut. Tightening torque : 27 ~ 31 N.m (2.8 ~ 3.2 kgf.m, 20 ~ 23 lb-ft) 2. If necessary of removing the wiper blad ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com