>

Hyundai Equus: Rear Stabilizer Bar Repair procedures - Rear Suspension System - Suspension System - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Rear Stabilizer Bar Repair procedures

Removal
1.
Remove the rear wheel and tire (A) from rear hub .

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

   
•
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

2.
Disconnect the rear stabilizer link (B) from the rear lower arm by loosening the nut (A)

Tightening torque:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

3.
Loosen the mounting bolt (A) and then remove the stabilizer bar (B).

Tightening torque:
45.0 ~ 55.0 N.m(4.5 ~ 5.5 kgf.m, 33.0 ~ 40.0 lb-ft)

4.
Disconnect the rear stabilizer link (B) with the stabilizer bar (A).

Tightening torque:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

5.
Install in the reverse order of removal.
Inspection
1.
Check the bushing for wear deterioration.
2.
Check the all bolts.
3.
Check the stabilizer bar for deformation.
    Rear Lower Arm Repair procedures
    Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     • Be careful not to damage ...

    Air Suspension System
    ...

    See also:

    Coolant
    The coolant should be changed at the intervals specified in the maintenance schedule. ...

    Carry emergency equipment
    Depending on the severity of the weather where you drive your car, you should carry appropriate emergency equipment. Some of the items you may want to carry include tire chains, tow straps or chai ...

    4&OD Clutch Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Categories

    Hyundai Equus Manuals

    © 2011-2025 Copyright www.heqmanual.com