Hyundai Equus: Over Pressure Valve (OPV) Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Over Pressure Valve (OPV) Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Over Pressure Valve (OPV) Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -"Release Residual Pressure in Fuel Line") |
| 3. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump") |
| 4. |
Release the fixing hook, remove the over pressure valve (A) from the fuel filter.
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Fuel Sender Assembly Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
"Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -""Release Residual Pres ...
Fuel Pump Control Module (FPCM) Description and Operation
Description
The fuel pump control module (FPCM) is installed on the right
side of the trunk compartment. It controls the BLDC (Brushless DC)
motor mounted inside the variable low pressure fuel ...
See also:
Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Remove the ECTS (Refer to "Removal").
3.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECT ...
Crash Pad Lower Panel Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply p ...
Power Trunk Module Drive Unit Schematic Diagrams
Circuit Diagram
...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com