>
Hyundai Equus: Fuel Sender Assembly Repair procedures
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
"Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -""Release Residual Pressure in Fuel Line"")" |
| 3. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump") |
| 4. |
Disconnect the fuel pump & sender ground (A).
|
| 5. |
Disconnect the fuel pump connector & fuel sender connector (A). |
| 6. |
Lift the fixing hook (B) by using a common driver, and then remove the fuel sender (C).
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Fuel Pump Motor Repair procedures
Over Pressure Valve (OPV) Repair proceduresSliding the Sunroof
The Engine Start/Stop Button must be in the ON position before you can open or
close the sunroof.
Pressing the sunroof control lever backward or forward momentarily to the second
detent posit ...
Cylinder Head Repair procedures
Removal
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damaging the cylinder head, wait until the engine
coolant temperature drops below nor ...
Repair procedures
Removal
1.
Remove the steering column upper and lower shrouds after loosening screws.
2.
Disconnect the multifunction switch connector (A).
3.
Remove the wiper & washer switch (A) by p ...