Hyundai Equus: Over Pressure Valve (OPV) Repair procedures

Fuel Sender Assembly Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. "Release the residual pressure in fuel line. (Refer to Fuel Delivery System -""Release Residual Pres ...

Fuel Pump Control Module (FPCM) Description and Operation

Description The fuel pump control module (FPCM) is installed on the right side of the trunk compartment. It controls the BLDC (Brushless DC) motor mounted inside the variable low pressure fuel ...

See also:

Repair procedures
Replacement     • Be careful not to damage the fender and body.     • When removing the clips, use a clip remover. 1. Loosen the front wheel ...

B Pillar Garnish Repair procedures
Replacement [B Pillar upper garnish]     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap it with pr ...

Presure Switch Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...