Hyundai Equus: Components and Components Location
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Blind Spot Detecation system / Components and Components Location
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Blind Spot Detecation system / Components and Components Location
| Components |
| 1. BSD (Blind Spot Detection) switch module (ON/OFF switch & state LED) 2. Speaker (Built in the cluster) 3. Head Up Display (HUD) | 4. BSD warning lamp (Built in the outside mirror) 5. BSD unit (RH : Master) 6. BSD unit (LH : Slave) |
Specifications
Specifications
ItemsSpecificationRated voltageDC 12VOperating voltage9V ~ 16VOperating speed15x/h ~ 250x/hSensible distance70m (Sedan)Curvature radiusStart : More than 100mStop : Less than 70mFre ...
Description and Operation
Description
The BSD (Blind Spot Detection) system uses a radar sensor to alert the driver while driving.
It senses the rear side territory of the vehicle and provides information to the driver.
- ...
See also:
Temperature Control Actuator Description and Operation
Description
The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
The signal from the control unit adjusts the position of the ...
Emission control system
The emission control system of your vehicle is covered by a written limited warranty.
Please see the warranty information contained in the Owner’s Handbook & Warranty
Information booklet in ...
Wheel nut tightening torque:
Steel wheel & aluminum alloy wheel: 65~79 lb·ft (9~11 kg·m)
If you have a tire gauge, remove the valve cap and check the air pressure. If
the pressure is lower than recommended, drive slowly ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com