Hyundai Equus: Room Lamp Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Lighting System / Room Lamp Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body Electrical System / Lighting System / Room Lamp Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Detach the lamp lens and reflector (A) from the room lamp with a flat-tip screwdriver.
|
| 3. |
Remove the room lamp (A) after removing the screws.
|
| 4. |
Replace the room lamp after removing the connectors (A).
|
Vanity Lamp
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the lens (A) using a flat-tip screwdriver.
|
| 3. |
Remove the vanity lamp (A) after loosening the mounting screws.
|
| 4. |
Remove the vanity lamp assembly after disconnecting the connector (A).
|
| Installation |
Room Lamp
| 1. |
Connect the connector and install the room lamp. |
| 2. |
Install the lamp reflector and lamp len. |
Vanity Lamp
| 1. |
Install the vanity lamp. |
| 2. |
Install the lens. |
| Inspection |
| 1. |
Check "IPM" input/output specification of room lamp using the GDS. |
| 2. |
Select option "Input/output monitoring".
|
| 3. |
Select option "Actuation Test" to perform functional test.
|
Rear combination lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Loose the nuts holding the rear combination lamp (outside) then disconnect the connector (A).
3.
Remove the rear combination la ...
Overhead Console Lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp (A) after loosening the overhead console lamp screw(2EA).
3.
Disconnect the sunroof switch conn ...
See also:
Front Wheel Speed Sensor Components and Components Location
Components
1. Front wheel speed sensor cable2. Front wheel speed sensor
...
Line Pressure Control Solenoid Vale Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Headlight escort function
If you turn the Engine Start/Stop Button to the ACC or OFF position with the
headlights ON, the headlights (and/or tail lights) remain on for about 5 minutes.
However, if the driver’s door is op ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com